Wipe off the surface that you will be applying
the FatMat to with a cleaner that will not leave a residue. Be sure
to get off all dirt and grease so that your FatMat bonds tightly.
This step will make a big difference in how permanent your application
of FatMat is. We have provided a cleanser degreaser simply dilute
it with about a half
Gallon of water and use as a spray. Be sure that surface is completely
dry before applying FatMat
Step 2:
If necessary cut your FatMat to
the needed size and shape with a utility knife then remove the backing
from your FatMat and apply to the surface that you have just cleaned.
Step 3:
Make sure that you use the roller provided,
this will ensure a tight bond between the FatMat and the surface.
(Your fingers cannot do the job properly!!!). By using the roller
you will be able to get the FatMat to stick securely to the different
contours. You may find it necessary to cut the FatMat during application
so that it lays flat on the surface. If is best to not leave any
air between the surface and the FatMat.
